AMD PCM-5896 User Manual download pdf (Page 29)

APPENDIX B

Frequently Asked Questions

The following FAQ was generated as a result of correspondence with tech-support at

EMAC and numerous other people on linux mailing lists. The FAQ details with subject

mater ranging from sound specific ALSA issues to hardware issues related to the SBC,

PCM - 5896.

Q. What are the standard boot-up procedures for the single board computer PCM 5896?

A. Here is the boot-up procedure for PCM 5896:

1) Make sure the 120 volts is not applied to the ATX supply while the connector is

plugged into the board, and while connecting any peripherals. As possible board damage

can occur (as there is a 5v output that is always on in the supply).

2) After the ATX power supply is connected to the board and the supply is plugged into

the wall, the jumper for the ATX power on switch needs to be triggered. This is done

with a momentary switch (if a hard jumper is used the board may not power up).

3) Also make sure the board is resting on a non-conducting surface. (i.e. paper, or plastic)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

No comments

AMD PCM-5896 User Manual Page 29